The successful NPI assembly and prototype assembly often requires greater attention to detail than a production build. Our dedicated NPI and Prototypes assembly team works closely with the customer and Project manager throughout the entire process to ensure on time delivery.
Our stand-alone low volume surface mount production and NPI prototype assembly is configured for rapid production bit of small batches. Deploy components don’t have to be supplied on reels, specially designed feeders for cut tape. Whether a very complex double side SMT board or conventional through whole technology, Triode can, subject to material availability and capacity, produce between one off and fifty off in only a 1 or 2. The triode team of expert individuals has been known to complete PCB assembly prototype boards in less than eight hours from the time.
Triode PCB receives the bare Printed Circuit Boards and Components. Easy and Flexibility to do hand loading is significant, at the same times it may be easier, cost effective and faster to partially hand load the project. This component count parts are placed by machine and way the fine pitch devices and the remaining placed by hand with the co-operation of computer software loaded with the bill of materials (BOM), co-ordinates and orientations placement.
Just as you can get PCB assembly fabricated on a panel sharing service, the triode performs stencil sharing. You are paying full price for a stencil (metal) which you may use only once, we will only charge you only according to the area required. This is one of the ways we keep your development costs to an always minimum.
Design for Manufacturability
Receiving feedback of the Design for Manufacturability post prototype production is critical to ensure that your products are suitable for capacity manufacture, and even better is preproduction feedback. At Triode PCB can provide not only a detailed DFM (Design for Manufacturability) report with recommendations to improve quality and reduce assembly costs once we have built your prototype, but Triode PCB can also do free pre-manufacture reviews using only your BOM (bill of materials) and Gerber’s (printed circuit board). Ask us about our Design for Manufacturability reports the next time you are preparing for a prototype assembly.